M3 Maintenance & Troubleshooting
These articles apply to both MakerGear M3-SE printers and M3-ID printers
- V4 Barrel Installation - This article will give instruction on replacing the barrel of ...
- Probe Tip Removal and Installation Guide - This article will show you how to remove and install the ret...
- Probe Removal and Installation Guide - This article will show you how to remove and install the BLT...
- Altering your start height manually (M Series) - Introduction: This article will demonstrate how to alter you...
- Multi-Color prints with a single extruder - How to print with multiple colors with a single extruder Intro...
- Manually pausing an active print - Manually pause an active print Introduction There are situatio...
- Removing the Filament drive - This article will show you how to remove the M3/Ultra One fila...
- V4 Hot End Removal and Installation - This article will show you how to remove and install the V4 h...
- Removing and Installing The V4 Nozzle - This article will show you how to properly change the nozzle ...
- Maintenance and Lubrication - Requirements: Clean lint free cloth. ISO 32 (SAE 10) such as ...
- Fuse Replacement - This article will teach you how to remove the fuses on your RA...
- Bed Prep and Maintenance - Maintain the perfect print surface for your needs. Keeping you...
- Basic Octoprint Troubleshooting - If you are able to connect to your Octoprint Interface but ar...
- Changing /Resetting Wifi - All new M3 3D Printers ship with Access Point Mode enabled. Th...
- The "Cold Pull" Nozzle-Cleaning Method - Unclog and/or clean your MakerGear hot end. Introduction The C...